Placement & Storage Conditions

Install the UPS in a protected area that is free of excessive dust, extreme temperature changes and has adequate air flow. Please place the UPS away from other units at least 20 cm to avoid interference. Do NOT operate the UPS where the temperature and humidity is outside the specific limits. (Please check the specs for the limitations)

Before storing, charge the UPS 5 hours. Store the UPS covered and upright in a cool, dry location.
Do not store the UPS for more than 3 months without connection to the mains.

During storage, recharge the battery in accordance with the following table:

Storage Temperature Recharge Frequency Charging Duration
-25°C - 40°C Every 3 months 1-2 hours
40°C - 45°C Every 2 months 1-2 hours

Charging

For the best results, suggest charging the battery at least 4 hours before initial use. The unit charges its battery while connecting to the utility.

Discharge the battery in a consistent interval for the Off-line and Interactive models. The best way to do it is once a month or once two months. The simplest discharge way is to turn on the UPS without connecting the mains.

Load capacity

Never overcharge the UPS. The maximum suggested load is 70%-75% of the supported maximum load.

Do not connect household electric devices (such as fan coolers) or laser printers. They could seriously damage the UPS.

Do not connect household electric devices (such as fan coolers) or laser printers. They could seriously damage the UPS.

lapara. Uninterruptible Power Supplies
contacto@laparaups.com

Lapara ® is a registered trademark. All rights reserved.